Adding STATUS file to indicate the pcb doesn't match the software

diff --git a/STATUS b/STATUS
new file mode 100644 (file)
index 0000000..be57b07
--- /dev/null
+++ b/STATUS
@@ -0,0 +1,15 @@
+- Software has not been updated for PCB rev 3.0. In particular, most of the pin
+assignments are incorrect.
+
+- USB bootloader is not implemented yet.
+
+- Configuration options are not yet loaded from EEPROM.
+- Configuration options cannot be set via USB.
+       - SCSI ID hardcoded to 0
+       - Partity checking is on
+       - Unit Attention Condition is off
+
+- Write performance is not adequate
+       - Multi-sector SD commands are not yet supported.
+       - DMA is not used for SPI transfers
+